Jura E80 - Dismantling and Rinsing the Fine Foam Frother; Inserting;Changing the Filter

32
5 Maintenance
To make sure the fine foam frother works properly, and in the inter-
ests of hygiene, it must be dismantled and rinsed daily if you have
been preparing milk.
T Remove the milk pipe and rinse it thoroughly under running
water.
T Remove the fine foam frother.
T Dismantle the fine foam frother into its individual parts.
T Rinse all the parts under running water. If there are severely
dried-on milk residues, firstly immerse the individual parts
in a solution of 8.5 oz (250ml) cold water and 1 capful of
JURA milk system cleaner. Then rinse the parts thoroughly.
T Re-assemble the fine foam frother.
E Ensure that all individual parts are correctly and firmly
connected to ensure optimum operation of the fine foam
frother.
T Re-fit the fine foam frother on the milk system.
Your E8 no longer has to be descaled if you are using the CLEARYL
Smart filter cartridge.
E Once the filter cartridge stops working (depending on the
water hardness setting), the E8 will prompt you to change
the filter.
Dismantling and rinsing
the fine foam frother
1
2
Inserting/changing the
filter