Jura GIGA6 - Setting the Water Hardness

28
4 Permanent settings in programming mode
T Touch ‘Switch off after’.
T Now move your finger to the left or right to change the
switch-off time.
T Touch
‘Save’.
‘Switch off after’
T Touch ‘Back’ the number of times needed to display the start
screen again.
You already set the time and date during first-time use. You can
change this setting in the machine settings (programme item
‘Time’
and
‘Date’).
E For the time format, you can choose between ‘24hrs’ and
‘AM/ PM’ (see Chapter 4 ‘Permanent settings in programming
mode – Unit for amount of water / time format’).
Example:Proceed as follows to change the time.
Precondition:The start screen is displayed.
T Press the Rotary Switch.
T Touch the ‘Machine setting’
f.
‘Switch off after’
T Turn the Rotary Switch until ‘Time’ is displayed.
T Touch
‘Time’.
‘Time’
T Enter the current time.
T Touch
‘Save’.
‘Time’
T Touch ‘Back’ the number of times needed to display the start
screen again.
The harder the water is, the more frequently the GIGA needs to be
descaled. It is therefore important to set the water hardness accu-
rately.
The water hardness was set when the machine was first used. You
can change this setting at any time.
The water hardness can be adjusted on a continuous scale between
1 °dH and 30 °dH.
Time and date
Setting the water
hardness