Jura GIGA6 - Language; Display Brightness

31
4 Permanent settings in programming mode
T Turn the Rotary Switch until ‘Save energy’ is displayed.
T Touch
‘Save energy’.
‘Save energy’
T Now move your finger across the controller and set it to ‘0’.
T Touch
‘Save’.
‘Save energy’
T Touch ‘Back’ the number of times needed to display the start
screen again.
In this programme item you can set the language used by your
GIGA.
Example:Proceed as follows to change the language from
‘English’
to
‘Français’.
Precondition:The start screen is displayed.
T Press the Rotary Switch.
T Touch the ‘Machine setting’
f.
‘Switch off after’
T Turn the Rotary Switch until ‘Choose language’ is displayed.
T Touch
‘Choose language’.
‘Choose language’
T Move your finger across the display until the desired lan-
guage, e.g.
‘Français’, is displayed in the centre.
T Touch
‘‘Enregistrer’’.
‘Langue’
T Touch ‘Retour’ the number of times needed to display the
start screen again.
In the programme item
‘Display’ you can set the display brightness
(as a percentage).
Precondition:The start screen is displayed.
T Press the Rotary Switch.
T Touch the ‘Machine setting’
f.
‘Switch off after’
T Turn the Rotary Switch until ‘Display’ is displayed.
T Touch
‘Display’.
‘Display’
Language
Display brightness