Jura GIGA6 - Product Settings Customization

25
4 Permanent settings in programming mode
Touch a product on the start screen for about 2 seconds to view the
list of settings:
U
‘Product settings’: Specify individual settings such as coffee
strength, amount of water, etc.
U
‘Initials’ (or ‘Product name’): Change the initials (or the name)
of the product.
U
‘Delete’: Delete the product from the start screen.
U
‘Replace product’: Replace the products on the start screen
with your favourites.
U
‘Copy product’: Duplicate any product, for example to create
a variant with a new product name and individual settings.
U
‘Double product’ (not for hot water): Create a double product
of the desired speciality.
The following settings can be set permanently for all speciality cof-
fees, milk and hot water:
Product Amount More settings
‘Espresso’ Water: 15ml–80ml Coffee strength (10 levels), temperature (low, normal,
high), left and/or right grinder (in %), product name,
delete/replace/copy/double product
‘Coffee’ Water: 25ml–240ml Coffee strength (10 levels), temperature (low, normal,
high), left and/or right grinder (in %), product name,
delete/replace/copy/double product
‘Caffè Barista’,
‘Lungo Barista’
Water: 25ml–240ml
Bypass water:
0ml–240ml
Coffee strength (10 levels), temperature (low, normal,
high), left and/or right grinder (in %), product name,
delete/replace/copy/double product
‘Espresso
doppio’
Water: 30ml–160ml
(2 strokes)
Coffee strength (10 levels), temperature (low, normal,
high), left and/or right grinder (in %), product name,
delete/replace/copy product
‘Jug of coffee’ Water: 25ml–240ml
Bypass water:
0ml–240ml
Coffee strength (10 levels), number of strokes (1–5),
temperature (low, normal, high), left and/or right
grinder (in %), product name, delete/replace/copy
product
‘Cappuccino’ Water: 25ml–240ml
Milk foam:
0sec.–120sec.
Coffee strength (10 levels), milk foam temperature,
temperature (low, normal, high), left and/or right
grinder (in %), product name, delete/replace/copy/
double product
Product settings
Adjusting the product
settings