Jura GIGA6 - Restore Factory Settings

32
4 Permanent settings in programming mode
T Now move your finger to the left or right to change the set-
ting.
T Touch
‘Save’.
‘Display’
T Touch ‘Back’ the number of times needed to display the start
screen again.
In the programme item
‘Factory setting’ the machine can be reset
to its factory setting: All user settings (apart from the ‘water hard-
ness’) are reset to factory settings. Your GIGA then switches off.
Precondition:The start screen is displayed.
T Press the Rotary Switch.
T Touch the ‘Machine setting’
f.
‘Switch off after’
T Turn the Rotary Switch until ‘Factory setting’ is displayed.
T Touch
‘Factory setting’.
‘Factory setting’ / ‘Reset the machine to the factory setting?’
T Touch ‘Yes’.
Your GIGA is switched off.
Your GIGA has a ‘Smart mode’. If this mode is activated, the prod-
ucts on the start screen will be rearranged according to the fre-
quency of preparation after some time. The number of products
displayed on the start screen will vary according to your personal
preferences.
E The star on the cockpit indicates that the ‘Smart mode’ is acti-
vated.
Example:Proceed as follows to deactivate the ‘Smart mode’.
Precondition:The start screen is displayed.
T Press the Rotary Switch.
T Touch the ‘Machine setting’
f.
‘Switch off after’
T Turn the Rotary Switch until ‘Smart mode’ is displayed.
T Touch
‘Smart mode’.
‘Smart mode’
Restore factory settings
Smart mode