JVA ELECTRIC FENCE SYSTEMS
15
Installation
5.4 Control
Your JVA Z114 security energizer has been designed for ease of operation.
Key Switch: In its simplest form, the energizer is controlled by the key switch on the
side of the unit.
Keypad: The energizer can be installed in a convenient location close to the fence,
while the keypad can be positioned in an easily accessible place. The systems
status information, e.g. mains power, energizer on/off, fence voltages, fence alarm,
auxiliary alarm, etc., are displayed on the keypad.
If a keypad is connected, the key switch and control input terminal may not be
operational as they may have been disconnected by the installer.
If both the key switch and keypad are connected to the energizer, then the last
change will determine the result. For example, if the unit is armed via the keypad and
then disarmed using the local key switch, it will disarm.
If in doubt consult your installer.
For a full description of operating the Keypad see section 8.
Arming the Fence Using the Keypad
deter and detect.
will indicate that there is a fault.
5.5 Turning to Low Power Mode
To switch to Low Power mode, enter your PIN and press *41#. In Low Power mode
the fence will still be powered and any breach will be detected, but the voltage will
Enter your PIN and press *42# to switch back to Full Power mode.
Alternatively, the unit can be switched to Low Power mode using a switch connected
to control input 2 (gate), if it has been programmed accordingly.
5.6 When an Alarm Occurs
then remain on. A siren or strobe connected to the unit will turn on. If the energizer
is connected to an alarm system for monitoring, an alarm signal will be sent to the
alarm company monitoring the alarm system.
An alarm will also sound if the gate input is opened and the entry/exit delay time has
elapsed.
To Next Page
Loading...
Need help?
General
