JVA ELECTRIC FENCE SYSTEMS
34
Function Description
Arm/Disarm [User PIN][#]
Silence an alarm (Single zone system only) [User PIN][#]
Start Programming the Z series energizer [Installer PIN][*] [0] [#]
Start Programming the Keypad [Installer PIN][*] [0] [1] [#]
Exit Programming (any mode) [*] [#]
Change a User PIN, 4 Digits [User PIN][*]0[#][New PIN]#
Change the Installer PIN, 5 Digits [0] [0] [New Installer PIN][#] Note 1
[User PIN][*][1][0][#]
Arm Zone 1 (Master) [User PIN][*][1][1][#]
Arm Zone x, where x is any zone number up to 15 [User PIN][*][1][x][#]
Disarm All Zones [User PIN][*][2][0][#]
Disarm Zone 1 or Master [User PIN][*][2][1][#]
Disarm Zone x, where x is any zone number up
to 15
[User PIN][*][2][x][#]
Switch to low power mode (all zones) [User PIN][*][4][1][#]
Switch to high power mode (all zones) [User PIN][*][4][2][#]
Arm Gate circuits only [User PIN][*][4][#]
To change the Keypad Messages to English [*][3][1][#]
To change the Keypad Messages to Spanish [*][3][2][#] (not well supported yet)
Keypad Audible Feedback On/Off [*] [5] [1] [#]
Keypad alarm beeper (Chime) On/Off [*] [5] [3] [#]
Keypad Error Tones On/Off [*] [5] [4] [#]
Backlight mode On/On with keys/Off [*] [8] [#]
Display Keypad Model [*] [9] [#]
[*][6][8][#]
[User PIN][*][6][8][#]
Reset and return to factory defaults [Installer PIN][*] [6] [8] [#] Note 5
Power Boost [*] [9] [9] [#]
Siren test [*] [6] [3] [#]
Battery test [*] [6] [4] [#]
Clear Alarm memory [*] [1] [#]
Notes:
1. Operates while in programming mode only.
JVA Z114 LCD Keypad Features
8.5 Summary of LCD Keypad Functions
To Next Page
Loading...
Need help?
General
