JVC DX-MX70BK User Manual

| DX-MX70Bk
Setting the Clock Setting the Timers
The clock will be displayed even when the system is turned off. Pressing the
TUNING/TIMER/DIMMER buttons (<J or &) will switch between two bright-
ness levels for the clock.
This system has three timers (TIMER 1, TIMER 2, DAILY) that are used
to turn the system on and off automatically:
With the timers you can make tape recordings of broadcasts, CD’s, or
1. Press the CLOCK ADJUST button on the Tuner. tapes when you're not around. You can also play these music sources
ares at specified times without recording them.
‘SDS
~
<
: Ss ®B Use TIMER1 and TIMER2 to record a radio broadcast when you're not
The hours digits blink. home, or late at night when you're asleep.
2. Press the TUNING/TIMER/DIMMER button (<I or >) to set the hours e Use the DAILY timer to record a broadcast that occurs at the same
digit. time every day.
@ The procedure for setting TIMER1, TIMER2, and the DAILY timer is
Leif Be the same. You need to tell the system:
— The name of the timer (TIMER1, TIMER2, or DAILY).
® Press the & button to increase the hour, and press the <I button to ~ The time the timer shouid turn the system on.
decrease the hours. — The time the timer should turn the system off.
® To enter a new hour digit, press the CANCEL button and repeat step 2. — The source the timer should turn on (Tuner, CD, or Tape).
eee. — The volume level that should be used during recording or playback.
fo) Note: The clock must be set to the correct time for the timers to be ef-
3. Press the MEMORY button on the Tuner. fective.
som Caution! Do not operate the remote controller when you are program-
@) ming the timer.
This sets the hour portion of the time.
The minutes digits will blink. Choosing a Timer
4. Press the TUNING/TIMER/DIMMER button (<I or >) to set the minutes Press the TIMER1, TIMER2, or DAILY button on the Tuner to select a timer.
digit. This puts the system in the Timer Setting mode. The information that the
system expects next will blink on the display.
@ it’s a good idea to set the minutes digits one minute ahead. Then you
can start the clock when it reaches the set time exactly (according : 2
to the correct time from the TV, radio, or telephone). Setting the Start Time
8 Toenter a new minute digit, press the CANCEL button and repeat step
4. 1. Press the TUNING/TIMER/DIMMER buttons to set the hour that the
system will turn on.
5. Press the MEMORY button. ‘4
20
The clock starts as soon as you press the MEMORY button.
Caution: If there is a power failure, or if you unplug the stereo, the clock
time will be lost. Repeat steps 1-5 when power is restored.
™ Use the TUNING/TIMER/DIMMER buttons to change luminosity of time
display by two steps under STANDBY status.
The <J button makes the hour number decrease, and the > button makes
the hour number increase.
2. Press the MEMORY button.
oO
This stores the hour portion of the start-time in memory.
3. Press the TUNING/TIMER/DIMMER buttons to set the minute.
4. Press the MEMORY button.
This stores the minute portion of the start-time in memory.

JVC DX-MX70BK Specifications

General

Brand	JVC
Model	DX-MX70BK
Category	Stereo System
Language	English