JVC DX-MX70BK User Manual

Using Turntable, VCR and DAT
In addition to the CD Player, Tuner, and Cassette Tape Deck, the amplifier
can also play a turntable, a VCR, and a DAT.
1. To play records, press the PHONO button on the Amplifier.
To play VCR or DAT, press the VCR/DAT button on the Amplifier.
2. To operate the each component, refer to its instruction manual.
B You can operate a JVC VCR and DAT using the remote controller. See
page 23 for more information.
Playing Back with a Surround Sound Effect
You can enjoy surround sound only with two speakers.
Press the SURROUND button.
The indicator light will go on.
Mixing the Microphone Sound
You can sing or narrate to the music with the optionally available microphone
connected to the MIC jack.
1. Connect the microphone.
® Set the MIXING LEVEL knob to SOURCE before connecting or disconnect-
ing the microphone.
2. Play your desired source.
3. Adjust the volume balance between the music and microphone using
the MIXING LEVEL knob.
MIXING LEVEL
The music volume ( ) The microphone
increases. SOURCE MIC volume increases.
Note: Raising the MIXING LEVEL too high may cause howling.
© Do not hold the microphone toward the speaker or move it away
from the speaker.
Lower the microphone level with the MIXING LEVEL knob.
Lower the volume level with the VOLUME knob.
® When the microphone is no in use, set the MIXING LEVEL knob to SOURCE.
10
| DX-MX70BK
Using the LEARNING CSRP Feature
The LEARNING CSRP (Compu-tink Source Related Preset system) is the state-
of-art electronic feature that tearns VOLUME and other control settings on
each source. This was previously done automatically each time a difference
source was played back or each time the system was turned off. It remem-
bers the last five settings of each parameter you has set and automatically
recalls the most frequently used ones.
This feature lets you invoke your favorite control settings by simply selecting
@ source (TAPE, TUNER, CD, VCR/DAT, PHONO) without repeating many
settings each time sources are changed.
When the LEARNING CSRP button is set to ON, the following parameters
are learned each time a difference source was played back or the system
was turned off.
‘@ Volume level
@ SEA settings (Preset Pattern and display mode)
They will be set based on the last five settings.
mw SEA ON/OFF
@ SURROUND ON/OFF
They will be set to the last setting.
Press the LEARNING CSRP button
Le:
LEARNING CSRP
©
The indicator light will go on.
- When sources are switched, the VOLUME level, SEA, and SURROUND
are automatically set.
- When turning the POWER off, the VOLUME control automatically turns
toward MIN.
- When turning the POWER on again, the VOLUME control automatically
turns up to the position set by the LEARNING CSAP function.
Using the Loudness Function
The loudness function will makes up for loss of the human auditory sensa-
tion when the sound is low.
1. Press the SEA button to turn the SEA on.
2. Press the SEA PRESET button to select a preset pattern other than
MANUAL.
3. Press the LEARNING CSRP button.
The indicator light will go on.
- If the volume level is lowered:
Low and high frequencies are boosted to make the sound powerful and
distinct.
- If the volume level is raised:
The SEA setting becomes similar to the preset pattern and thee Sound
becomes natural.

JVC DX-MX70BK Specifications

General

Brand	JVC
Model	DX-MX70BK
Category	Stereo System
Language	English