JVC DX-MX70BK User Manual

@ The tape is automatically rewound to the beginning of side A, and then
recording begins.
@ When the Tape Deck is set in auto reverse mode, after the last track
is recorded on side A, the tape deck high-speed-erases to the end of
side A. Then it changes direction to side B and begins recording the
remaining tracks.
® To stop recording, press the STOP button on deck B, or press the
STOP/CLEAR button on the CD Player.
Note: The program cannot be edited during recording. To change the
program, press the STOP/CLEAR button on the CD Player and begin with
step 4 of this procedure.
Note: During recording in the Programmed-Edit Mode, do not operate
the CD Player.
Recording with the SEA Function
The SEA Function is used to alter the tone of the source by increasing or
decreasing the levels of selected frequency ranges.
You can use this function to contro! the way the tracks from the CD will sound
when they are recorded on the tape.
1. Insert the cassette for recording in deck B.
2. Press the SEA button on the Amplifier.
@ The indicator light will go on,
® To create the desired sound, see ‘‘Controlling Sound with the SEA
Function’’ on page 9.
3. Press the <J or > button on the Tape Deck while holding down the
REC/REC MUTE button.
Recording starts.
SEA Function Notes
@ The SEA Function cannot be used during high-speed dubbing.
@ If the source you are recording from is a cassette in deck A that was
created using Dolby noise reduction, the noise reduction effect is lost
when you dub using the SEA Function.
® To keep the noise reduction effect of the cassette in deck A, use either
of these methods:
— High-speed dubbing.
— Normal speed dubbing, with the SEA Function off and the DOLBY NR
button set to OFF.
@ When LEARNING CSRP is ON, do not change the volume level during
recording because the loudness feature will cause the SEA settings
to be altered.
18
DX-MX70BK
Creating a Blank During
Recording
Use the Record Muting function when you do not want to record a section
of the source.
1. Press the REC/REC MUTE button on the Tape Deck at the beginning
of the section you don’t want to record.
EC) aT,
A blank of about 4 seconds is created on the cassette, and then the deck
pauses.
2. To start recording again, press the <J or > button.
@ To create a blank of more than 4 seconds, hold down the REC/REC
MUTE button. When you release this button, the deck pauses.
@ When the source you are recording from is the CD Player and the CD
DIRECT REC button is used, the REC/REC MUTE button will not
function.
Recording with the Timer
This compact component system can be set up to record a tape automati-
cally. This is especially useful for recording broadcasts when you are not
around, or late at night when you are asleep.
1. Insert a cassette for recording into deck B.
2. Set the timer, by following the steps in ‘‘Setting the Timers’ om page
18.
3. Select one of the following sources:
TUNER TIMER REC
—— TIMER REC
Records TUNER preset stations
Records from the source selected be-
fore turning off the system

JVC DX-MX70BK Specifications

General

Brand	JVC
Model	DX-MX70BK
Category	Stereo System
Language	English