19
ENGLISH
When Using an SD Card
If you want to record to an SD card, the
following three operations need to be
performed.
•
Operations are guaranteed on the following
SD cards.
Video recording: Class 6 compatible SDHC
card
Still image recording: Panasonic, TOSHIBA,
SanDisk, ATP (128MB to 4 GB) or SDHC
card (4GB)
•
If other media are used, they may fail to
record data correctly, or they may lose data
that had already been recorded.
•
MultiMediaCards are not supported.
•
Files in full high-definition picture quality
cannot be recorded on an SD card.
•
Cards used to record video on this camera
cannot be played back on other devices.
Q Insert an SD card
Preparation:
Set the power/mode switch to OFF.
1 Open the SD card cover.
2 Firmly insert the card with its clipped
edge first.
3 Close the SD card cover.
8 To remove an SD card
Push the SD card once.
After the card comes out a little, pull it out.
NOTES
•
Insert and remove the SD card only while
the power is turned off. Otherwise, data on
the card may be corrupted.
•
Do not touch the terminal on the reverse
side of the label.
R Change the recording medium
The camera is programmed to record on the
built-in hard disk when it is shipped from the
factory. You can change the recording medium
to SD card.
Set [REC MEDIA FOR VIDEO] and
[REC MEDIA FOR IMAGE] to [SD].
(Z pg. 68, 69)
NOTE
Video picture quality (Z pg. 68) will
automatically be set to [SP].
S Format an SD card when using it for
the first time
This will also ensure stable speeds and
operation when accessing the SD card.
Select [EXECUTE] in [FORMAT SD
CARD] to format the card. (Z pg. 72)
Bottom of the
Camera
Clipped Edge
To Next Page
Loading...
