JVC Everio GZ-HD7

70
Changing the Menu Settings (Continued)
Menus Settings: [ ] = Factory-preset
Y GENERAL
<
DATE/TIME
Enables you to set whether to
display the current time on the
LCD monitor.
OFF: The date/time does not appear.
[AUTO]: The date/time appears for approx. 5 seconds in
the following cases.
•
When the power/mode switch is set from OFF to
STANDBY/ON
•
When playback starts
ON: The date/time is always displayed.
Z PRESET
Returns all the camera settings
to their default values.
EXECUTE: Performs this function.
[CANCEL]: Returns to the menu screen without
executing reset.
g BRIGHTBRIGHT
Enables you to set the brightness
of the LCD monitor or viewfinder.
Adjust the brightness of the display moving the set lever
to
£
/
¤
, then press down.
^ DROP DETECTIONDROP DETECTION
Prevents damage to the
HDD by turning off the power
automatically when the camera
detects that it has been dropped.
OFF: Disables the function.
[ON]: Activates the function.
To turn the unit on when the drop detection
worked, set the power/mode switch to OFF, and to
STANDBY/ON again.
CAUTION
Setting this function to off increases the chances of
damaging the built-in hard disk if the camera is accidentally
dropped.
N
FOCUS ASSIST
When the focus assist function
is used, the borderline of the
focused subject is displayed in
the selected color.
[BLUE] / RED / GREEN
] REMOTEREMOTE
Turns reception of the operation
signal from the remote control
on/off.
OFF: The camera does not receive the signal from the
remote control.
[ON]: Enables operation with the remote control.
[ DEMO MODEDEMO MODE
Introduces special features of
the camera when there is no
operation for about 3 minutes
during recording mode.
OFF: Disables the function.
[ON]: Activates the function.
NOTES
•
The demonstration only works when the AC adapter is
connected, not with the battery.
•
If an SD card is in the camera, demonstration will not take
place even if this mode is set to [ON].
\ OPERATION SOUNDOPERATION SOUND
Enables you to set the operation
sound or turn the operation
sound on/off.
OFF: Turns off the operation sound.
[MELODY]: The melody sounds when any operation is
performed.
O
TALLY LAMP
Set whether to light the tally lamp
while shooting.
OFF: Unlit.
[ON]: Lit.