JVC GY-HM150U - Page 10

1-10 (No.HC044<Rev.001>)
(2) Remove the two screws A attaching the upper cover (VF),
then remove the upper cover (VF).
Fig.29
(3) Remove the one screw B attaching the wire.
(4) Remove the two screws C and the two screws D attaching
the holder (VF) assembly, then remove the holder (VF) as-
sembly.
Screw C: Short Screw D: Long
Fig.30
(5) Remove the four screws E attaching the bottom case (VF),
then remove the bottom case (VF).
(6) Remove the two screws F attaching the LCD module as-
sembly, then remove the LCD module assembly.
Fig.31
(7) Remove the two tabs, then remove the front cover (VF).
• Removing the front cover (VF) enables to release the
lens and other parts.
Fig.32
(8) The parts on the LCD module assembly are fixed only with
the tabs. When assembling the parts, be careful with the at-
taching order and direction of each part.
Fig.33
A
Upper cover (VF)
C
D
B
Holder (VF)
assembly
E
LCD Module assembly
Bottom case (VF)
F
F
Tabs
Front cover (VF)
Lens holder
assembly
LCOS Bracket
LCOS Cover
LCOS Holder
LCD Module
Note the boss breaking.
Support plate side
FPC
Terminal side
VF Board
Terminal side