JVC GY-HM150U - Removing the View Finder Assembly

1-6 (No.HC044<Rev.001>)
(5) Remove the four screws G and the one screw H attaching
the case (HDD), then remove the case (HDD).
Screw G: Short Screw H: Long
Fig.6
(6) Remove the one screw J and the one screw K attaching
the OPE unit.
Screw J: Short Screw K: Long
(7) Pull out the wire from the connector CN204
on the ANA-
LOG board, then remove the OPE unit.
Fig.7
(8) Remove the six screws L and the one screw M attaching
the upper assembly.
Screw L: Short Screw M: Long
(9) Pull out the wire from the connector CN107 on the MAIN
board, then remove the upper assembly.
• When attaching the upper assembly, be sure to set the
two tabs firmly.
Fig.8
3.3 Removing the view finder assembly (See Figure 9, Fig-
ure 10, Figure 11)
(1) Remove the four screws A attaching the rear cover assem-
bly, then remove the rear cover assembly.
Fig.9
(2) Remove the one screw B attaching the REAR board.
(3) Pull out the wire from the connector CN6001
on the MAIN
board, then remove the REAR board.
Fig.10
(4) Pull out the wire from the connector CN205
on the ANA-
LOG board.
(5) Remove the five screws C attaching the view finder assem-
bly, then remove the view finder assembly.
Fig.11
G
H
G
Case (HDD)
J
K
CN204
OPE Unit
ANALOG
Board
L
L
M
L
L
Set the tabs firmly
Set the tabs firmly
CN107
MAIN Board
Upper assembly
A
A
Rear cover
assembly
REAR Board
B
CN6001
MAIN Board
C
C
View finder assembly
CN205
ANALOG Board