(No.HC044<Rev.001>)1-9
(9) Remove the two screws H and the one screw J attaching
the frame (upper).
(10) Remove the four tabs, then remove the frame (upper).
(11) Remove the one screw K attaching the OPE1 board as-
sembly, then remove the OPE1 board assembly.
Fig.25
3.6 Removing the monitor assembly (See Figure 26, Figure
27)
• Removing the monitor assembly from the upper assembly.
(1) Remove the two screws A and the two screws B attaching
the monitor cover assembly, then remove the monitor cov-
er assembly.
Screw A: Narrow Screw B: Thick
(2) Pull out the wires from the connectors CN701
, and CN703
on the MONI board, then remove the hinge unit assembly.
Fig.26
(3) Removing the four screws C attaching the bracket (LCD)
enables to release each part.
• When assembling the parts, be careful with the assem-
bling order and direction of each part.
• Do not push the LCD surface as it may be damaged.
• Be careful in handling the surface of the LCD and the
monitor, and do not damage, soil, or leave fingerprints. If
the surfaces are soiled, gently wipe them off with soft
cloth.
Fig.27
3.7 Removing the view finder assembly (See Figure 28,
Figure 29, Figure 30, Figure 31, Figure 32, Figure 33)
• Remove the view finder assembly from the main unit.
(1) Remove the eye cap.
• When attaching the eye cap, align the positions as
shown in the figure.
Fig.28
H
K
J
OPE1
Board
assembly
Frame (upper)
Tab
Tabs
A
B
Monitor cover assembly
Hinge unit
assembly
CN703
CN701
C
LCD Bracket
Spacer (LCD)
LCD Module
Support plate
side
LCD Case
Turn
Put it on slit
of MONI case.
MONI Case assembly
Sheet BEF
Sheet (M.DIFF)
Light guide
Sheet (M.REF)
MONI Board
Match and attach this position.
Eye cap
To Next Page
Loading...
