JVC GY-HM150U - Specific Service Instructions; Disassembly; Removing the Bottom Cover Assembly; Removing the Upper Assembly

(No.HC044<Rev.001>)1-5
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
SECTION 3
DISASSEMBLY
3.1 Removing the bottom cover assembly (See Figure 1)
(1) Remove the seven screws A attaching the bottom cover
assembly.
• The screws indicated with the marks need not be re-
moved.
Fig.1
3.2 Removing the upper assembly (See Figure 2, Figure 3,
Figure 4, Figure 5, Figure 6, Figure 7, Figure 8)
(1) Remove the four screws A attaching the shoe assembly,
then remove the shoe assembly.
Fig.2
(2) Remove the four screws B attaching the grip cover, then
remove the grip cover.
• Before attaching the grip cover, attach the three tabs on
the grip cover first.
Fig.3
(3) Remove the two screws C and the two screws D attaching
the jack cover, then remove the jack cover.
Screw C: Short Screw D: Long
Fig.4
(4) Remove the three screws E and the one screw F attaching
the upper cover assembly, then remove the upper cover
assembly.
Screw E: Short Screw F: Long
Fig.5
A
Bottom cove
r
assembly
A
Shoe assembly
B
B
B
Tabs
Grip cover
D
D
C
C
The Jack cover is done in
the slide while pushing arrow
"a" part.
Jack cover assembly
Open the
mic cover
aa
F
E
E
Upper cover assembly