JVC GY-HM150U - Removing the Boards and the OP Block Assembly

(No.HC044<Rev.001>)1-7
3.4 Removing the boards and the OP block assembly (See
Figure 12, Figure 13, Figure14, Figure 15, Figure 16,
Figure 17, Figure 18, Figure 19, Figure 20)
(1) Pull out the wire from the connector CN108
on the MAIN
board.
(2) Remove the three screws A attaching the focus ring as-
sembly, then remove the focus ring assembly.
Fig.12
(3) Remove the two screws B attaching the MIC assembly.
(4) Pull out the wire from the connector CN206
on the ANA-
LOG board, then remove the MIC assembly.
Fig.13
(5) Remove the four screws C attaching the bracket (bottom)
and the bracket (frame), then remove each bracket.
Fig.14
(6) Pull out the wires from the connectors CN201
, CN202, and
CN203
on the ANALOG board.
(7) Remove the two screws D attaching the ANALOG board,
then remove the ANALOG board.
Fig.15
(8) Remove the three screws E attaching the bracket (MAIN).
(9) Pull out the wire from the connector CN901
on the SD
board, then remove the bracket (MAIN) and the SD board.
(10) Pull out the wires from the connectors CN103
, CN6003,
and CN110
on the MAIN board, then remove the MAIN
board.
Fig.16
(11) Remove the three screws F attaching the heat sink (MAIN),
then remove the heat sink (MAIN).
Fig.17
A
A
A
Focus ring
assembly
CN108
MAIN Board
B
MIC Assembly
CN206
C
C
C
Bracket (Frame)
Bracket (Bottom)
D
D
A
NALOG
Board
CN6003
CN201
CN202
CN203
E
E
CN901
SD Board
CN103
CN110
MAIN
Board
F
F
Heat sink
(MAIN)