JVC GY-HM150U - Page 12

1-12 (No.HC044<Rev.001>)
(4) Remove the four screws D attaching the XLR board.
(5) Pull out the wire from the connector CN2802 on the XLR
board, then remove the XLR board assembly.
Fig.40
(6) Remove the three screws E attaching the AU cover (SW),
then remove the AU cover (SW).
• The slide knob comes off at the same time. When attach-
ing the AU cover (SW), be careful with the direction of the
slide knob.
Fig.41
(7) Remove the two screws F attaching the audio VR knob,
then remove the audio VR knob.
Fig.42
(8) Remove the three screws G attaching the XLR2 board,
then remove the XLR2 board.
Fig.43
(9) Remove the two screws H attaching the AU cover (BTM),
then remove the AU cover (BTM).
Fig.44
(10) Remove the four screws J attaching the shoe plate, then
remove the shoe plate, lock screw, and the lock spring.
• See the figure when attaching the shoe plate, the lock
screw, and the lock spring.
Fig.45
D
D
D
XLR Board assembly
CN2802
Fix convex shape of
knob with mark.
E
Slide knob
Slide knob
AU Cover (SW)
F
Suppress the outside of knob,
and fix the screw.
attach the knob so that the print
side may become right.
Audio VR knob
G
X
LR2 Board
H
AU Cover (BTM)
Pass the screw a part of
extended slit.
A
Detail of how to fix
Slide screw like arrow afte
r
pass A of the lock screw
J
Shoe plate
Lock spring
Lock screw