JVC GY-HM150U - Page 24

1-24 (No.HC044<Rev.001>)
5.1.6 EEPROM Menu Operation
(1) Refer to 5.1.1 to display the SERVICE MENU.
(2) Move the cursor to [EEPROM], then press the [Set] button
or the [Cross-Shaped] button (right).
(3) The EEPROM Menu is diaplayed.
(*1):It sets to the code changed according to the conversion ta-
ble of the following table.
Item Parameter
Model ID 0 01h Factory use.
1 4F Factory use.
2 8B Factory use.
Node Uniq 0 00h Not use.
1 00h to FFh The left of a serial number to the 1st
figure, and the 2nd figures.
2 The left of a serial number to the 3rd
figure.
3 The left of a serial number to the 4th
figure, and the 5th figures.
4 The left of a serial number to the 7th
figure, and the 8th figures.
Serial No. 0 00h to FFh The left of a serial number to the 1st
figure. (*1)
1 The left of a serial number to the 2nd
figure. (*1)
2 The left of a serial number to the 3rd
figure. (*1)
3 The left of a serial number to the 4th
figure. (*1)
4 The left of a serial number to the 5th
figure. (*1)
5 The left of a serial number to the 6th
figure. (*1)
6 The left of a serial number to the 7th
figure. (*1)
7 The left of a serial number to the 8th
figure. (*1)
All Reset CANCEL Does not reset.
Reset * The data of EEP-ROM is returned
to a setup at the time of factory ship-
ments. (Adjustment data and hour
meter data are excluded.)
* A setup at the time of shipment
changes with sale areas. (I: Japan,
U: America, E: Europe, EC: China)
Number Input code
030h
131h
232h
333h
434h
535h
636h
737h
838h
939h
G47h
M4Dh
V56h