(No.HC044<Rev.001>)1-33
(4) Data
There are six types of EEPROM data. Each data is displayed in different color on the EEPROM Utility screen.
5.6.5 Temperature information
(1) On the SSS main screen, click [Option]-[About Temperature (OP)] to check the internal temperature (internal temperature near
OP).
• The CCD needs to be fully warmed up for white blemish correction. The internal temperature of the unit (the temperature near
OP) must be 47.5°C or higher (43h or less).
Check the internal temperature in About Temperature (OP).
5.6.6 Non-communication mode
In the non-communication mode, The SSS can be used without connecting the unit. The EEPROM saved in the disk can be checked.
(1) On the “Serial Port Configuration” screen in starting the SSS, press and hold the “L” key on the keyboard, then click [OK].
(2) A warning screen appears, click [OK].
Color Type Description Details
Light blue Fixed data Data that not change by CPU. Model code, etc.
Pink Adjusting data Data that is changed by adjustment. Adjustment data.
Light green No Fixed data Data that may be changed by CPU. Focus/Zoom position memory, etc.
Orange Default setting data Data that is changed by usage. Menu setting, emergency, etc.
Dark magenta Doctor data Data that not change. Doctor program.
Yellow PE data Data that not change. Data that is used during production.
Before correcting white blemish,
check that the internal
temperature is 47.5 C or higher.
(EEPROM data:43h or less)
Press and hold, then click
To Next Page
Loading...
