Operation Lock Feature
You can use this feature to prevent erroneous
camera operation.
.
1
While in the Camera mode (when the
display screen appears), press and hold
the [CANCEL/STOP] button for 5 seconds
or longer.
0
The operation lock
turns on, and an operation
lock icon (r) appears on the display
screen.
.
1/100
F1. 6
18
dB
AE+6
ND 1 /1 6
12 :34 :56
Jan 24,2015
00:00: 00.00
4030 20 10 0
5 . 6 f t
P 15000K
0
Press the [CANCEL/STOP]
button again for
5 seconds or longer to turn off the operation
lock.
Memo :
0
The operation lock feature is only valid in the
Camera mode.
(A P20 [Operation Modes] )
0
The power turns off and the operation lock is
disengaged.
0
The following remote operations are possible
even when the operation lock feature is turned
on (“On”).
0
Remote operation from the wired remote
control connected to
the [REMOTE] terminal.
0
Remote operation of the camera through
access via a browser on devices such as a
smartphone, tablet terminal, or PC.
Operation lock does not apply to the following
buttons and switches.
0
[
POWER ON/OFF] switch
0
[
AUDIO INPUT INPUT1]/[AUDIO INPUT
INPUT2] Audio input signal selection switch
O
0
[CH-1]/[CH-2] Audio input signal selection
switch O
0
[AUDIO SELECT CH-1 AUTO/MANU]/[AUDIO
SELECT CH-2 AUTO/MANU] Audio recording
mode switch O
0
Focus ring
0
Zoom lever at
the grip/Zoom lever at the handle
O/Zoom ring at the lens section
0
[ZOOM L/M/H] Zoom Speed Switch
O
0
Iris Dial
0
[REC/HOLD] Record Trigger Button/Lock
Switch O
0
[
REC] button (on the grip)
0
Visibility Adjustment Lever
0
User button that has been assigned with the
[Rec] function.
48
Operation Lock Feature
Preparations
To Next Page
Loading...
