Turning On/Off the Power
Turning On the Power
0
To use the battery, refer to “Charging the Battery Pack” (A
p. 5) .
o
When the AC adapter is connected
1
Connect the AC adapter to the “DC” terminal
.
2
Set the “STANDBY/ON OFF” switch to “ON”.
.
0
The camera recorder starts up in Camera mode.
0
The camera recorder always start up in Camera mode when the
power is turned on.
o
“CAM/MEDIA” operation mode and indicating lamp status
Use the “CAM/MEDIA” operation mode selection switch to switch to a
different mode. The “CAM” indicating lamp and “MEDIA” indicating lamp
change as below.
Mode “CAM” Indicating
Lamp
“MEDIA” Indicating
Lamp
During Camera
mode
Lights up in red Light goes out
During Media
mode
Light goes out Lights up in red
.
0
To switch to the Media mode, turn the “CAM/MEDIA” selection switch, or
press the “CAM/MEDIA” button.
(You can also use the “<<CAM/<<MEDIA” button on the touch screen.)
Turning Off the Power
1
Set the “STANDBY/ON OFF” switch to “OFF”.
.
o
Auto power off feature
If the unit is running on battery alone, and “AUTO POWER OFF” in the
common menu is set to “ON”, the unit will turn off automatically if it is not
operated or does not operate for 5 minutes.
“ AUTO POWER OFF ” (A p. 115
)
Memo :
0
When both
the battery and AC adapter are connected, power from the AC
adapter connection will be used. As such, the “AUTO POWER OFF”
function will not have any effect.
Getting Started
11
To Next Page
Loading...
Need help?
General
