Masterpage:Right-No-Heading
27
Filename [XVS30EK_07S-VHS.fm]
Page 27 September 2, 2003 4:58 pm
K
Engage the unit’s timer mode.
Press #. The unit turns off automatically and “#”
appears on the front display panel.
● To disengage the timer mode, press # again.
To Timer-Record Weekly Or Daily Serials:
— anytime during steps D through I, press WEEKLY (number
key “9”) for weekly serials or DAILY (number key “8”) for daily
serials (Monday – Friday). Either “WEEKLY” or “DAILY” appears
on the TV screen. Pressing the button again makes the
corresponding indication disappear.
NOTES:
● You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a
ninth, “PROGRAM FULL” appears on the TV screen and
“FULL” appears on the front display panel. To record the extra
programme, you must first cancel any unnecessary
programmes. (
墌 “To cancel or change a programme”)
● If there is a conflict in the timer schedule and one programme
overlaps with another, the programme starting earlier or
programme with the lower programme number will be
recorded.
Check, cancel and change programmes
A
Disengage the timer mode.
Press #, then press 1.
B
Access the Programme Check screen.
C
Access the Programme screen.
To cancel or change a programme
D
Cancel or change a programme.
Press & to cancel a programme. To change programme
settings, press the appropriate button: START +/–,
STOP +/–, DATE +/–, PR +/–, PDC (number key “7”),
DAILY (number key “8”), WEEKLY (number key “9”) and/
or p.
E
Return to the normal screen.
Press " as many times as necessary. If there are still
some programmes remaining, go on to step F.
F
Return to the timer mode.
Press #.
NOTE:
You can also check the programmes on the front display panel
even if the unit’s power is off (unless the unit is in the Power Save
mode
墌 pg. 66) or the unit is in the Timer mode; however, it is
not possible to cancel or change the programmes.
Satellite Receiver Users
To timer-record a satellite broadcast using Express Timer
Programming:
A Set “L-2 SELECT” to “A/V”. (
墌 pg. 57)
B Perform steps A – K. Enter “L-2” for the channel position
in step G.
C Set the satellite receiver to the appropriate channel before
the selected programme begins.
D Leave the satellite receiver’s power on.
Press ".
Press " again to check
more information. Each time
you press ", the next
programme’s information
appears.
XVS30EK_01.book Page 27 Tuesday, September 2, 2003 5:01 PM
To Next Page
Loading...
