42
ENGLISH
3
Start searching an ensemble.
When an ensemble is received, searching stops.
4
Select an service you want to listen to.
To stop searching before an ensemble is received, press the same button you have pressed
for searching.
To change the display information while tuning into an
ensemble
Normally service name is shown on the upper part of the display.
If you want to check the ensemble name or its frequency, press DISP.
Each time you press the button, the following information appears for a while on the upper
part of the display.
To restore the FM/AM tuner
Press and hold FM/AM/DAB for more than 1 second again.
To tune in a particular ensemble without searching:
1 Press and hold FM/AM/DAB for more than 1 second.
2 Press FM/AM/DAB repeatedly to select the DAB band (DAB1, DAB2, or DAB3).
3 Press and hold
¢ or 4 for more than 1 second.
4 Press
¢ or 4 repeatedly until the ensemble you want is reached.
• If you hold down the button, the frequency keeps changing until you release the button.
To search
ensembles of higher
frequencies.
To search
ensembles of lower
frequencies.
RPT
MO
RND
5
∞
Ensemble nameService name
Channel number Frequency
EN41-46.KD-SX979R[E]/f 00.1.20, 2:09 PM42
To Next Page
Loading...
Need help?
General
