JVC KW-V250BTM - Using an External Navigation Unit; Bluetooth; Information; Preparation

Other External ComponentsOther External Components
Using an external navigation unit
(Only for KW-V250BT Region 3/KW-V250BTM
Region2)
You can connect an external navigation unit
(commercially available) to the NAV input terminal so
that you can view the navigation screen. (Page 40)
• The navigation guidance comes out of the front
speakers even when you are listening to an audio
source.
Viewing the navigation screen
• For settings, see <Navigation> on page 33.
Select “NAV” as the source.
On the Home screen, touch as follows:
• While the navigation screen is displayed, the touch
panel operations are available only for navigation.
• The aspect ratio of the navigation screen is fixed
to <FULL> regardless of the [ ] setting.
(Page12).
When receiving a call during navigation guidance
The screen is switched automatically. To return to the
navigation screen, touch [ - ] on the pop-up
short-cut menu.
To exit the navigation screen
On the pop-up short-cut menu, touch [ - ] .
Bluetooth® Bluetooth®
Information
Bluetooth is a short-range wireless radio
communication technology for mobile devices such as
mobile phones, portable PCs and other devices.
Bluetooth devices can be connected without cables
and communicate with each other.
Note
• While driving, do not perform complicated
operations such as dialing numbers, using the phone
book, etc. When you perform these operations, stop
your car in a safe place.
• Some Bluetooth devices may not connect to this unit
depending on the Bluetooth version of the device.
• This unit may not work for some Bluetooth devices.
• Connecting conditions may vary depending on your
environment.
• For some Bluetooth devices, the device is
disconnected when the unit is turned off.
• If your mobile phone supports PBAP (Phone Book
Access Profile), you can display the following items
on the touch panel when the mobile phone is
connected.
– Phone book
– Dialed calls, received calls, and missed calls (up to
10 entries in total)
Preparation
For KW-V250BT Region 3:
Select the microphone (built-in or external) to use. See
<MIC SETUP> on page 26.
For KW-V250BT Region 4/KW-V250BTM Region 2:
Connect and install the microphone beforehand. For
details, see page 41.
Connection
When you connect a Bluetooth device to the unit for
the first time:
1 Register the device by pairing the unit and the
device.
2 Connect the device to the unit. (Page22)
Registering a new Bluetooth device
Pairing allows Bluetooth devices to communicate with
each other.
• The pairing method differs depending on the
Bluetooth version of the device.
– For devices with Bluetooth 2.1:
You can pair the device and the unit using SSP
(Secure Simple Pairing) which only requires
confirmation.
– For devices with Bluetooth 2.0:
You need to enter a PIN code both on the device
and unit for pairing.
• Once the connection is established, it is registered in
the unit even if you reset the unit. Up to five devices
can be registered in total.
• Two devices for Bluetooth phone and one for
Bluetooth audio can be connected at a time.
However, when “BT Audio” is selected as the source,
you can connect up to five Bluetooth audio devices
and switch between these five devices.
• To use the Bluetooth function, you need to turn on
the Bluetooth function of the device.
21
ENGLISH
03_KWV_2019ST_MM2X_Body01.indd 2103_KWV_2019ST_MM2X_Body01.indd 21 18/6/2018 11:36:00 AM18/6/2018 11:36:00 AM