Bluetooth®Bluetooth®
• The status is shown as follows:
<Connecting>: Connection is in progress.
<Connected>: A connection has been established.
<Connect Ready>: A connection is ready to be
established.
<Disconnecting>: Disconnection is in progress.
<Disconnected>: No connection is established.
• When a Bluetooth mobile phone is connected, the
signal strength and battery level are displayed when
the information is acquired from the device.
To delete the registered device: Perform step 1,
select the device you want to delete in step 2, then
touch [Remove].
• A confirmation message appears. Touch [Yes].
Bluetooth mobile phone
When a call comes in...
Touching the operation keys performs the following
actions:
[ ]
Answers a call.
[
]
Rejects a call.
• Call information is displayed if acquired.
• Phone operation is not available while the picture
from the rear view camera is displayed.
2 Select the device (1) you want to connect,
then touch [Connection] (
2).
3 Select the device (1) to connect, then
return to the <Paired Device List> (
2).
Select [ON] (to connect) or [OFF] (to disconnect).
: Mobile phone
: Audio device
4 Connect the selected device.
• For KW-V250BT Region 3/KW-V250BTM Region 2:
When receiving a call during navigation guidance,
the screen is switched automatically.
– To return to the navigation screen, touch [ ].
During a call...
Touching the operation keys performs the following
actions:
[ ]
Ends a call.
[
] /
[ ]
Switches between handsfree mode and
phone mode.
[DTMF] Enters DTMF (Dual Tone Multi
Frequency), then sends text using the
keypad.
NR LEVEL
[–] / [+]
Adjusts the noise reduction level.
(–5 to 5)
EC LEVEL
[–] / [+]
Adjusts the echo volume level.
(–5 to 5)
MIC LEVEL
[–] / [+]
Adjusts the volume level of the
microphone. (–10 to 10)
• Press the volume + / – buttons on the monitor panel
to adjust the volume of the call or earpiece.
23
ENGLISH
03_KWV_2019ST_MM2X_Body01.indd 2303_KWV_2019ST_MM2X_Body01.indd 23 28/6/2018 3:09:53 PM28/6/2018 3:09:53 PM
To Next Page
Loading...
