SettingsSettings
System settings
Display the <System> screen.
On the Home screen, touch as follows:
Then, on the <Settings> screen, touch [System].
E.g. System settings screen
<Language>
Select the text language used for on-screen
information. For details, see “Initial settings” on
page4.
“Please Power Off” appears when the setting is
changed. Turn off the power, then turn on to enable
the change.
<Clock>
Set the clock. For details, see “Clock settings” on
page5.
<Smartphone Setup>
Specify the connection method of Android/iPod/
iPhone.
1 Select the device type (1), then touch
[Change] (
2).
2 Select the connection method (1), then
confirm the selection ([OK] or [Next]) (
2).
If [iPod/iPhone] is selected in step 1:
[USB 1 Wire] Select this when the device is
connected via the USB input
terminal on the monitor panel.
[Bluetooth] Select this when the device is
connected via Bluetooth. (Go to
step 3.)
Make sure that A and B are horizontally parallel, and
that C and D are the same length.
• Touch and hold [Initialize ] for 2 seconds to set all
the marks to the initial default position.
<Navigation>
(Only for KW-V250BT Region 3/KW-V250BTM
Region2)
Change the settings for displaying the screen of an
external navigation unit.
• To change the setting, turn off the AV source by
touching [AV Off] on the Home screen beforehand.
<Input>
Select the source screen to be displayed when you
perform the following operation.
Touch [ - ] on the pop-up short-cut menu.
• RGB: Switches to the navigation screen from the
connected navigation unit.
• OFF (Initial): Deactivates the display switch function.
<Output>
Select which front speakers are used for the navigation
guidance.
• Lch: Output from front left channel only.
• Rch: Output from front right channel only.
• L+Rch (Initial): Output from both front left and front
right channels.
<Volume>
0 to 35 (Initial: 21): Adjust the volume of the navigation
guidance.
33
ENGLISH
00_KWV_2019ST_MM2X_EN.indb 3300_KWV_2019ST_MM2X_EN.indb 33 1/6/2018 12:07:08 PM1/6/2018 12:07:08 PM