Installation and ConnectionInstallation and Connection
REVERSE
REMOTE CONT
STEERING WHEEL
REMOTE INPUT
P.CONT
ANT.CONT
PRK SW
*1
¥
‘
*2
Wiring connection
10 A fuse
Connect the antenna cord to the antenna terminal
Purple with white stripe
White
]
/ White with black stripe
[
Green
]
/ Green with black stripe
[
Gray
]
/ Gray with black stripe
[
Purple
]
/ Purple with black stripe
[
Orange with white stripe
Light blue with yellow stripe
Blue with white stripe (12 V
350 mA)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
Light green
To the car’s reverse lamp harness when using the optional rear view camera
To the car light control switch
To rear speakers (right) / Tweeters (right) for 3-way crossover
To front speakers (right) / Mid-range speakers (right) for 3-way crossover
To rear speakers (left) / Tweeters (left) for 3-way crossover
To front speakers (left) / Mid-range speakers (left) for 3-way crossover
Car battery
Car fuse
To the car chassis
To the OE remote adapter (not supplied) which is compatible with your car
To the power control terminal when using the optional power amplifier (Or)
To the control terminal of the motor antenna or to the power terminal for the booster amplifier of film-type antenna
Extension wire (
ø
)
To the car’s parking brake detection switch harness
(For best safety, be sure to connect the parking sensor.)
Ignition key switch
*1 Only for KW-V250BT Region 3/KW-V250BTM
Region 2.
*2 Only for KW-V250BT Region 4/KW-V250BTM
Region 2.
41ENGLISH
04_KWV_2019ST_MM2X_Body02.indd 4104_KWV_2019ST_MM2X_Body02.indd 41 18/6/2018 11:36:46 AM18/6/2018 11:36:46 AM
To Next Page
Loading...
