JVC RV-NB200BT - Programming Tracks and Files; Procedure for Audio CD; Procedure for Audio Files

15
Programming tracks and files
YoucanusetheremotecontroltoprogramtracksonanaudioCDorlesina sequence of your
choice. The following number of storage locations is available:
 AudioCD:20memoryslots Files:99memoryslots
Procedure for audio CD
1.Thesource"CD"mustbeinstopmode,otherwisenoprogrammingispossible.
2.Pressthe
PRG
button to start the programming mode.
3. The display now shows "P01 T--001".Thesecondnumberblockshowsthecurrenttrack,therst
number block the current memory location.
4.Usethe or button to select the track you want to save to the current memory location.
5.Pressthe
PRG
buttontoconrmtheoperation.
6.Afterthat,thenextmemorylocationwillbedisplayed.Repeatsteps4and5untilyourselectionis
complete or the number of memory slots is full. In this case "Full" appears in the display.
7. Using the uII button you can start the playback of the programmed tracks.
8.Pressingthe button twice clears the programming.
Procedure for audio files
1.Thesource"USB"mustbeinStopmode,otherwisenoprogrammingispossible.
2.Pressthe
PRG
button to start the programming mode.
3. The display now shows "P01 F--01 001"an.Therstnumberblockshowsthecurrentmemory
 location,thesecondnumberblockthecurrentfolderandthethirdblockthecurrenttracknumber.
4. Using the
Fold+
or
Fold-
button you can select a folder or keep the current folder.
5.Usethe or button to select the track you want to save to the current memory location.
6.Pressthe
PRG
buttontoconrmtheoperation.
7.Afterthat,thenextmemorylocationwillbedisplayed.Repeatsteps4and6untilyourselectionis
complete or the number of memory slots is full. In this case "FULL" appears in the display.
8.Usingthe uII button you can start the playback of the programmed tracks.
9. Pressing the button twice clears the programming.
• If the buttonispressedduringprogramming,theprocessisaborted.Switchingoffthe device
deletes an existing program.