JVC RV-NB200BT - Selecting a DAB + Station; Storing Stations in the Station Memory

17
Manual tuning of ensembles
• Press the "MENU" button on the device to enter the DAB menu.
• Press the button until "Manual tune" appears in the Display.
• Pressing the uII buttonconrmsthefunctionandthecurrentlysetchannelwiththecorresponding
frequency is shown in the display.
• Press the button to manually select another channel.
• Press uII toconrmtheselection.Afterthat,thesignallevelisshowninthedisplay,another press
loads the current ensemble.
Selecting a DAB + station
The stations stored alphabetically in the station list can be called up as follows:
• Press the
TUN+
or
TUN-
button on the remote control to scroll backwards or forwards in the
station list.
•Whenthedesiredstationisselected,pressthe uII button on the remote control to start playback.
The Display will show"Playing".
•Ifthereceptionlevelontheselectedstationisinsufcientfortrouble-freeplayback,"Service not
available" appears in the display. In this case please select another station.
Storing stations in the station memory
TostoreDABstationsforeasierretrieval,30memoryslotsareavailable.Toassignthememory,please
proceed as follows:
• Select a station to save
• Press the
PRG
button until the "Preset Store" and a memory location is showed on the Display.
An empty memory location is displayed with"Empty",anassignedmemoryspacewiththenameof
the sender. You can also reassign an already assigned memory.
• Use the or buttons to select a memory location.
•Brieypressthe uII button to save the station. Thedisplaybrieyshows"Preset X Stored".
• The stations can now be selected using the or button on the device.