JVC RX-730R - Naming Preset Radio Stations; Assigning Custom Names to Presets

Page 22
English
Assigning Names to Preset Stations
You can assign a name of up to five characters to each preset station (from preset channel number 1 to 20).
When a preset station is tuned in, its assigned name will appear on the display.
On the front panel only:
1. Tune in a preset station (preset channel number 1 to 20).
See page 21 for details.
2. Press MEMORY (next to the TUNER button).
The preset channel number starts flashing.
Note:
If you press Control % / fi while the preset channel
number is flashing, you can change the preset channel
number.
3. Press Control
##
##
# (or
@@
@@
@) until the first character
position starts flashing.
4. Press Control
%%
%%
% /
fifi
fifi
fi to select a character.
You can use characters listed below.
5. When a character you want appears, press
Control
##
##
# (or
@@
@@
@).
The next (or previous) character position starts
flashing.
6. Repeat steps 4 and 5 to enter up to five characters.
7. Press MEMORY (next to the TUNER button) again while the last selected character is flashing,
after you have assigned a name.
To erase the input characters
Insert blanks using the same procedure described above.
MEMORYTUNER
MENU
See also
page 39.
Available characters
CBADEGFHIJKLMNO
SRQTUWVX
Y
Z01234P
87695
Blank
MEMORYTUNER
Front panel
VISUAL CONFIRMATION
CH–
100 1k 10k
VISUAL CONFIRMATION
CH–
100 1k 10k
VISUAL CONFIRMATION
CH–
100 1k 10k
VISUAL CONFIRMATION
CH–
100 1k 10k
RX-730RBK(EF)0054-001A.En.01-28 97.7.25, 6:27 PM22