35
English
Basic Settings
Some of the following settings are required after connecting and positioning your speakers, while others will make
operations easier.
Basic setting operations are only possible while the receiver is ready for Zone 1 operations.
Setup Menu Configuration
SETUP MENU (1)
SETUP MENU (2)
1 SPEAKER SETTING
(See page 38.)
4 SUBWOOFER
(See page 40.)
3 SPEAKER DISTANCE
(See page 40.)
2 CHANNEL LEVEL
(See page 38.)
5 THX AUDIO SETUP
(See page 41.)
6 SURR CH OUT
(See page 42.)
7 AUDIO DELAY
(See page 42.)
SETUP MENU (2)
8 DUAL MONO
(See page 42.)
9 DIGITAL IN/OUT
(See page 42.)
p VIDEO INPUT
(See page 43.)
w ZONE 2/SPEAKER 2
(See page 43.)
q VIDEO POWER
(See page 43.)
e SUPERIMPOSE
(See page 44.)
r FL DISPLAY
(See page 44.)
t ONE TOUCH OPE
(See page 44.)
SETUP MENU (1)
Note:
When performing the basic settings viewing the indications on the
main unit’s display, the indications are slightly different from what are
shown on the on-screen display.
This is because of the limited number of characters shown on the
main unit’s display.
Ex. • “SPEAKER SETTING” is shown as “SP SETTING” on the main
unit’s display.
• “SPEAKER DISTANCE” is shown as “SP DISTANCE” on the
main unit’s display.
NOTICE—
• Items on the menus shown above are all set to the initial
values when shipped from the factory.
* However, the SPEAKER DISTANCE, SUBWOOFER, and
THX AUDIO SETUP submenu settings are not the initial
ones. They are the settings when “SUBWOOFER” is set to
“YES” on the SPEAKER SETTING submenu.
• Some of the menus or some items on the menu cannot be
shown or cannot be adjusted. (For details, see the respective
explanations in this section.)
EN35-44_RX-DP20VBK[C]f 03.6.12, 2:14 PM35
To Next Page
Loading...
Need help?
General
