JVC SP-AP1-B - Adjust the Volume; Turning off the System

9English
English
• To check the current source, press and
hold [DIMMER/STATUS]. The front
indicator lamp will light for 3 seconds.
(hold)
3
Adjust the volume.
(press repeatedly) (press repeatedly)
Remote control System
Adjustable range: MIN, 1 to 39, MAX
• When the volume is set to the minimum
or maximum value, the front indicator
lamp lights for an extended period.
Temporarily muting the system
• To restore the sound, press the button
again or press [VOLUME +/−].
Turning off the System
The System will go into one of the 2 following
standby modes, depending on how the
System is turned off.
Turn the System on automatically when
enjoying AirPlay/DLNA (network standby)
In network standby mode, an AirPlay/DLNA
device can be used to turn the System power
on automatically (Auto power on) by selecting
the System, "SP-AP1", and starting playback.
Make sure that the wireless function is ON.
• To enter network standby mode, press [
]
(standby/on).
Remote control System
• The STANDBY indicator lights faintly in
white when in network standby mode.
• To use network power on, set up a network
between the System and an AirPlay/DLNA
device. (page 10)
• See page 14 for information about AirPlay/
DLNA devices.
• The Auto power on function does not work
for BLUETOOTH connections.
Put the System into an energy efficient
standby mode (normal standby)
Press and hold [
] (standby/on) for 4
seconds or longer with the wireless function
turned ON.
Remote control System
(press and hold) (press and hold)
• The STANDBY indicator lights in red when
in normal standby mode.
• When the wireless function is OFF, the
system enters normal standby mode,
regardless of the length of time the [
]
(standby/on) button is pressed for.
Lights faintly in
white
Lights in red
When in network
standby mode
When in normal
standby mode
SP-AP1[E]04.indd9SP-AP1[E]04.indd9 2013/10/1614:192013/10/1614:19
Downloaded from www.vandenborre.be