805.13
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
LWF Page 00: Feeder Overview, Continued
Page 00
variable list
con't
Variable Name Edit? Description
Drive Command This value indicates how much of
the controller output is used to
deliver indicated actual massflow
value.
Range of Operation
Maximum Range: 0-125 %
Nominal Range: 0-100 %
Desired Range: 10%-100 %
Totalizer Value # This value is the quantity of
product that has been delivered in
either Kgs or Lbs since the last time
the Totalizer was reset or cleared.
Range of Operation
Maximum Range: 999,999.999
Motor Speed If the Total Gear Reduction is set to
1.0 and the Gear Teeth Setpoint is
correct, then this value represents
the motor rpm of the feeder.
Page 00 special
key list
The following is a listing of keys and their function.
Key
Number
Key Name Description
F3 Totalizer Clear Will clear the totalizer value on
page 00 to zero.
To Next Page
Loading...
Need help?
General
