K-TRON K-Commander User Manual

805.31
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
LWF Page 03: Current Alarm Messages, Continued
Alarm
message table
with cause and
remedy
Note: If you see a message with three capital characters together like
DHS, DLS, you can be assured that they are mnemonics used by the
serial data channel and information can be found in the serial protocol
section.
Alarm Cause Remedy
External Alarm
Active Alarm
A digital input on the
K10S Controller Pc
board is active.
Clear external alarm
input to K10S
controller Pc board.
Drive Comm Greater
than DHS Alarm
Actual Drive
command is greater
than the Alarm
setpoint called Drive
Command High
Limit, see K-Cdr page
Mcn.04.
The setpoint is too
high for the given
conditions of feeder
and material.
Material blockage
possible. Important if
Mass Flow Low alarm
is present.
Drive Comm less that
DLS Alarm
Actual Drive
command is lower
than the Alarm
setpoint called Drive
Command Low
Limit, see K-Cdr page
Mcn.04.
Setpoint is too low for
a given material
and/or feeder. Re-
size equipment to up
drive command.
Fdr Controller
Timeout Alarm
External channel data
communications
between K10S Pc
board and K-Cdr has
failed.
Check baud rates at
both ends of data
channel, check power
at K10S Pc board,
Review leds on K10S
Pc board.
Fdr Internal Channel
Failure Alarm
Internal channel of
K10S Pc board has
failed.
Check physical
connections and slave
device that is
connected to this data
channel.
Continued on next page

K-TRON K-Commander Specifications

General

Brand	K-TRON
Model	K-Commander
Category	Control Panel
Language	English