805.40
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
LWF Page 04: Alarm Limits, Continued
Page 04
variable list
con't
Variable Name Edit? Description
Drive Command High
Alarm Limit
` Sets the point above which, if drive
command goes, will result in an
alarm called High Drive
Command.
ex: This entry is 80%, If drive
command exceeds this value, an
alarm will occur.
Range of Values
5 to 100 %
Default value: 100%
Drive Command Low
Alarm Limit
` Sets the point below which, if drive
command goes, will result in an
alarm called Low Drive Command.
ex: This entry is 10%, If drive
command goes below this value, an
alarm will occur.
Range of Values
0 to 95%. Must be 5% or more
below Drive Command High
Limit
Default value: 0%
Continued on next page
To Next Page
Loading...
