K-TRON K-Commander User Manual

805.67
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
LWF Page 07: Service Variable Index, Continued
Service
variable index
and value
listing con't
Pert Residual
Moving average of
the current PERT
level. More
responsive to
disturbance than
MSD.
The smaller the
number, the better the
feeder is functioning
in your process. Work
to lower the number
via changes to the
environment in which
the feeder operates.
Low Motor Gain
Limit
An entered limit that
if the Motor Control
Gain, page Mcn.09,
drops below, an
alarm occur.
0 = default
Max = 100
Alarm is "Low Motor
Gain"
Calibrate Time Time for feedfactor
calibration
30-300 seconds
Refill Timer 2 This timer becomes
active when the
regular Refill Timer
expires. If the net
weight is still below
the Refill Request
point after this timer
expires, the controller
will display the real
massflow while the
controller remains in
volumetric control.
The Kalman filter
parameters remain
unchanged.
0 seconds is default
maximum setting
>100,000
WBF Slip Idler Y/N For weigh belt feeder
applications.
Continued on next page

K-TRON K-Commander Specifications

General

Brand	K-TRON
Model	K-Commander
Category	Control Panel
Language	English