K-TRON K-Commander User Manual

805.93
K-Commander Loss-in-Weight Programming
Rev: G Produced by the K-Tron Institute
Setting "Refill Complete", 27
Setting "Refill Request Weight", 28
Setting the "Post Refill Mode Delay", 29
SFT Configuration, 53
SFT Failure Codes, 53
SFT Raw Weight, 52
SFT Type Code, 53
SP, 69
SP and Alarm, 69
Span calibration by taking rate samples, 49
Span calibration procedure using weights, 48
SPC Cycle Thru Snapshots Key, 86
SPC End of Log, Add New Point Key, 86
SPC End of Log, Add New Points Key, 86
SPC Message - Alarm Snapshot. N
SPC Message - Display Frozen, 85
SPC Message - No Points Logged Yet, 85
SPC Message - No SPC Variable Selected, 85
SPC Message - Real-time Display, 85
SPC Message - Start of Log, 85
SPC More Keys, 86
SPC Move Backward Key, 86
SPC Move Forward Key, 86
SPC note for data retrieval, 85
SPC Start of Log Key, 86
SPC Values - Lower Control Limit, 84
SPC Values - Standard Deviation, 84
SPC Values - Upper Control Limit, 84
SPC Variables to Log, 82
SPC X-Bar Sample Width, 82
SPC Zoom In Key, 86
SPC Zoom Out Key, 86
Special addressing for SFT's using the Quad Controller, 54
Speed Pick-up Gear Teeth, 58
Standard keys and their functions, 3
Standard keys and their functions con't, 4
Start-up Delay Setting, 41
Stop Bit Message, 36
Stop Clrs Alarms, 62
STP, 2
T
Tare, 2, 47
Tare calibration procedure, 48
Total Gear Reduction, 58
Totalizer Clear, 13
Totalizer method for span calibration, 50
Totalizer Value, 13
U
Units Selection, 56
Use Refill Array (LWF only), 62
V
Vol Mode, 3
Volumetric control, 2
W
WBF Slip Idler Y/N, 67
Weight Processor Failure Alarm, 34
Weight Sample Time (msec), 75
Weight Span, 46
When F5-Edit is pressed, 6
Window above F2 key, 5
Window above F4 key, 5
Window above F5 key, 5
Window above F6 key, 5
Window over F1 key, 5
Z
Zero Setpoint Message, 36

K-TRON K-Commander Specifications

General

Brand	K-TRON
Model	K-Commander
Category	Control Panel
Language	English