Kaba PowerLever 1550 - SERVICE; Remove Outside Lever - Conventional Cylinder; Remove Outside Lever - Interchangeable Core

Document Number 481.093 Rev. A - 06/04
21
SERVICE
Remove the Outside Lever
Conventional (Non-Interchangeable) Key
Cylinder
Note: Refer to Figure 25.
1. Insert the key and turn the key in the cylinder 45
degrees clockwise.
2. Push the lever release tool into the hole in the lever to
depress the lever catch.
3. Pull the lever off of the tube.
4. If the lever was latched at the second latch point, it
will be necessary to repeat Steps 1 and 2 with the
lever release tool inserted in the second hole in the
lever.
Interchangeable Key Core
Note: Refer to Figures 26 and 27.
1. Insert the control key into the core and turn the key
clockwise.
2. Pull out the core and tailpiece.
3. With a screwdriver positioned inside the lever, push
the inside of the lever catch toward the hinge and pull
the lever off of the tube.
Note: The lever catch is a thin plate. Be careful to
engage only the lever catch and not the parts
behind the catch.
Figure 25 - Model 45xx Shown
Figure 26
Figure 27
Service