KAESER ASD 40 - Acknowledging Alarm and Warning Messages; Fig. 22 Switching on and off with the Clock; Tab. 43 Machine Identification

Fig. 22 Switching on and off with the clock
1 «clock» key
2 clock key
1. Attach an easily seen notice warning of time-controlled operation:
DANGER!
This machine is time-controlled and can start automatically at any time.
Tab. 43 Machine identification
2. Press the «clock» key.
The clock LED lights. The machine is switched on and off by the clock.
8.5 Acknowledging Alarm and Warning Messages
Messages are displayed on the "new value" principle:
■ Message received: LED flashes
■ Message acknowledged: LED lights
■ Message gone: LED extinguished
or
■ Message received: LED flashes
■ Message gone: LED flashes
■ Message reset: LED extinguished
8 Operation
8.5 Acknowledging Alarm and Warning Messages
9_5721 06 USE
Service Manual Screw Compressor
ASD T Tri-Voltage
49