Operating Instructions
Insert and replace batteries
Replace the batteries immediately when the symbol
appears in the display. Disconnect the meter from the power
source. Remove the test leads from the measuring device,
loosen the screws on the back and remove the lower half of
the housing, replace the old batteries and screw the cover back on.
Turn on/off the meter
The device is switched on when the rotary switch (5) is set to a measuring function. When the
rotary switch is set to OFF, the measuring device is switched off.
Automatic shutdown
No operation in 15 minutes, the clamp meter beeps 3 times. Without further operation, the clamp
meter beeps again and switches off automatically.
Press any key to restore the clamp meter to operating status. The symbol appears on the display.
To deactivate the automatic switch-off, hold down the "FUNC.” key for more than 2
9
To Next Page
Loading...
