10. Setup via front keys
Date, time and primary M-Bus address can be adjusted by means of the
keys on the calculator’s front.
1 In the display you select the reading you want to change
2 Disconnect the supply plug from the meter
3 Wait until the meter has switched off (up to 2.5 minutes).
Do not press any keys
4 Keep pressing the main key
while the supply is connected to
the meter (connecting the supply plug to the meter) until no lines
are shown in the display
5 The setup menu is now active
Having activated the setup menu the reading you want to change is
displayed and at the same time the digit at the far right of the display
flashes:
The value of the flashing digit can be changed by pressing the
subkey
. The digit is increased by one each time you press the key,
and at 9 it reverts to 0:
21
To Next Page
Loading...
