Kamstrup MULTICAL 402 - 2.2 Pocket sensors

8 Kmsrup A/S • 5512850_D1_GB_01.2016
MULTICAL® 402
2.2 Pocket sensors
The sensor pockes cn be
mouned in e.g.  welding sleeve
or in  45° lerl Y-piece. The ip
of he sensor pocke mus  les
rech he cener of he flow pipe.
Push he emperure sensors
s deep s possible ino he
pockes. If  shor response ime is
required, “nonhrdening” hermlly
conducive pse cn be used. Push
he plsic sleeve on he sensor
cble ino he sensor pocke nd
secure he cble by mens of he
enclosed M4 seling screw. Fsen
he screw wih your fingers only.
Sel he pockes using sel nd
locking wire.
B
B
SECTION
B-B
SCALE
1 : 1