Kamstrup MULTICAL 402 - Mounting of Flow Sensor; 4.1 Mounting of couplings as well as short direct sensor mounted in MULTICAL402 flow sensor

10 Kmsrup A/S • 5512850_D1_GB_01.2016
MULTICAL® 402
4 Mounting of flow sensor
Prior o insllion of he flow sensor, he sysem should be flushed nd
proecion plugs/plsic diphrgms removed from he flow sensor.
Correc flow sensor posiion (inle or oule) ppers from he fron lbel of
MULTICAL® 402. The flow direcion is indiced by n rrow on he side of he
flow sensor.
4.1 Mounting of couplings as well as short direct sensor mounted in
MULTICAL®402 flow sensor
The shor direc sensor from
Kmsrup my be mouned in
PN16 insllions only, wheres
he blind plug which is mouned
in he MULTICAL® 402 flow sensor
from he fcory my be used in
connecion wih boh PN16 nd
PN25 insllions.
The flow sensor my be used in
boh PN16 nd PN25 insllions
nd is vilble mrked eiher PN16
or PN25 s required.
Enclosed couplings, if ny, re only
inended for PN16. Suible PN25
couplings mus be used in PN25
insllions.
In connection with G3/4x110 mm
and G1x110 mm it must be checked
that 10 mm thread run-out is
sufficient. See the figure to the
right.
Gske
Momen pprox. 4 Nm
Gske
10 mm