Kamstrup MULTICAL 801 Technical Description

MULTICAL® 801
12
Kamstrup A/S · Technical Description · 5512-571_R1_GB_11_2016
3 Type overview
MULTICAL
®
801 can be ordered in countless combinations as required by the customer. First, you select the
required hardware from the type overview. Then select ”Prog”, ”Config” and ”Data” to suit the application in
question.
The supplied meter is configured from the factory and ready for use, however it can be changed/reconfigured after
installation.
Please note that the points marked “Total prog” cannot be changed without breaking the verification seal. This
means that the change must be carried out by an accredited meter laboratory.
We currently develop new functions and modules for MULTICAL
®
801. Please contact Kamstrup A/S if your
application is not covered by the variants shown.
3.1 Type and programming overview
Type number 67-x-x-xx-xxx-xxx
Total prog
Choice of calculator, modules,
sensor pairs and flow sensor
Prog. A-B-CCC-CCC
Total prog
Config. DDD-EE-FF-GG-M-N
Partial prog.
Data
Partial prog.

Kamstrup MULTICAL 801 Specifications

General

Brand	Kamstrup
Model	MULTICAL 801
Category	Measuring Instruments
Language	English