10
• Source to Single Receiver Routing: To route a source to a receiver, click and drag
the source’s button on the left to the preferred display on the right side, then release
the mouse button. If the routing was completed successfully, the newly routed
source’s name will appear below the display’s name within the button. Clicking on
any source button will change the color of itself, and all currently routed displays.
Note: Receivers may also be drag and dropped onto sources to activate a new route.
• Source to Multiple Receiver Routing: To route a source to multiple receivers at the
same time, click and drag the source’s button on the left to a pre-defined Video Group
or “All” button on the right side, then release the mouse button. If the routing was
completed successfully, the source’s name will appear within all appropriate buttons.
• All/Native/Multiview Stream Stop: In certain situations, it may become necessary
to stop one or all of the video streams coming from a source. To do this, first select
the type of stream to stop by clicking on the cycle selection icon ( ) at the bottom
of the window until the preferred option (All Stop, Native Stop, Multiview Stop) is
displayed. Next, click and drag the source down to the chosen “Stop” button. The
chosen stream type will be immediately terminated. To stop a stream type from
ALL video streams simultaneously, drag the “All” button down to the chosen “Stop”
button. “All Stop” stops all stream types from the selected source, “Native Stop”
stops only the full resolution primary video stream, “Multiview Stop” stops only the
secondary video stream used by multiviewer layouts.
• Video Receiver: This section provides drag-and-drop buttons for all receivers
detected by the system as well as a button target to stop one or all output streams
from being displayed.
• Stop Stream: To stop the video stream on a single display, drag the display down to
the “Stop” button at the bottom of the window, then release the mouse button. To
stop ALL video outputs, drag the “All” button down to the “Stop” button.
• Status Icons: Status icons will be displayed instead of a video thumbnail image under
the following conditions:
To Next Page
Loading...
