4
1. INTRODUCTION
The KanexPro SDVoE powered Modular Matrix system is the most versatile flexible
video distribution solution. The system is composed of transceiver devices that can be
configured as either video transmitters or receivers with a simple click of a mouse. The
whole system is controlled and configured by a single control module which makes
setup a snap. Add the system to a 10G network and enjoy UHD 4K Lossless video with
zero latency.
The KanexPro Modular Matrix Controller (EXT-PROCTRL) is a powerful and flexible tool
for controlling multiple SDVoE (Software Defined Video over Ethernet) based extender
transceivers within same network. Install this unit onto the same local network as the
extenders to easily define and configure channel routing selections using the WebGUI. It
is also possible to define and switch routes using customized groups or presets allowing
for easy control over multiple video zones. Without the use of this controller, each
individual Transmitter and Receiver pair could only be configured in a basic point-to-
point operational mode.
Additionally, this unit supports controlling and configuring the matrix, video wall, and
multiviewer modes of connected SDVoE units. The settings of all connected transmitter/
receiver units, including IP configuration, compatibility settings, and extender status are
clearly displayed within the WebGUI. A trigger input interface is also provided to allow the
easy addition of a remote control keypad, or other trigger-supporting products, which can
be installed within a podium or table in a conference room or classroom. This interface can
allow the user to activate stored macros with the simple press of a button. Standard control
is available via WebGUI (remote or local), RS-232, Telnet and IR Remote.
2. APPLICATIONS
• Video/TV wall display and control
• Security surveillance and control
• Commercial advertising, display and control
• Home Theaters with Smart Home Controls
• Retail sales and demonstration
3. PACKAGE CONTENTS
• 1x EXT-PROCTRL IP Master Controller (SDVoE)
• 1x 5V/2.5A DC Power Adapter
• 1x Terminal Block (3-pin)
• 3x Terminal Block (5-pin)
• 1x IR Extender Cable
• 1x Remote Control (CR-183)
• 1x Shockproof Feet (Set of 4)
• 1x Operation Manual
To Next Page
Loading...
