21
*.bin file. Click the “Choose File” button to locate the saved *.bin file, then click the
“Open” button.
• Save Log: A comprehensive system log file to help diagnose configuration issues or
other problems can be generated, if requested by technical support. Click the “Save
Log” button to save a copy of the current log data in, *.zip format, to your local PC.
Note: The generated file is password protected and is only intended for use by authorized
technical support.
• Factory Reset: Resets the unit back to its factory default settings.
• Note: This Factory Reset does NOT clear the transmitter and receiver history tables.
To completely remove old transmitter and receiver units from the system, use the
“Remove” option on the Transmitter and Receiver tabs.
• Reset all transmitters/receivers: Reset all detected transmitters or all detected
receivers back to their factory default settings.
• Reboot System: Reboot this unit.
• Reboot all transmitters/receivers: Reboot all detected transmitters or all detected
receivers.
• S/N: Displays the unit’s serial number.
3. Firmware Upgrade: Provides a method to remotely update the firmware of this unit
as well as to update the firmware of detected transmitters and receivers.
Note: The update process can take several minutes to complete, especially if there are a large
number of transmitters and receivers in the system. Please do not power off any units during the
update process.
• IP Master Controller Firmware: To update the unit’s firmware click the “Choose File”
button to open the file selection window and then select an appropriate firmware
update file (*.bin format) located on your local PC. After selecting the file, click the
“Upgrade” button to begin the firmware update process. Once the firmware update
process has completed the unit will reboot.
• Kit Plugin: Provides a way to upgrade the system with additional, optional, plugins.
To upload a new plugin, click the “Choose File” button to locate the appropriate file
on your local PC, then click the “Open” button.
• Transmitter/Receiver Firmware: To update the firmware of all detected transmitters
or receivers, click the “Choose File” button to open the file selection window and
then select an appropriate firmware update file (*.apz format) located on your local
PC. After selecting the file, click the appropriate “Upgrade All” button to begin the
firmware update process on all transmitters, or receivers. Once the firmware update
process has completed the appropriate units will reboot.
Note: The transmitter/receiver firmware is stored within the IP Master Controller after upload and
will also be used when performing individual unit updates within the Transmitter and Receiver tabs.
To Next Page
Loading...
