36
• System Command: Use the dropdown to select a system command to send to the
unit. Typically available commands are:
- Factory Reset: Reset the unit back to its factory default settings.
- Reboot: Reboot the unit.
- Firmware Update: Update the firmware of this unit using the currently uploaded
firmware file.
- Transform (Transceivers only): Switch the unit into transmitter mode.
Name: Change the unit’s name (19 character maximum).
• HDMI Audio Source: Select the audio source type to embed with the HDMI video
output of this unit. Available options are:
- HDMI Audio (Follow Video In Bypass Mode): Output the HDMI audio routed to
this unit unless the receiver has been set to “Bypass Mode” in the scaling tab. When
“Bypass Mode” is active, only the native HDMI audio from the routed video source
can be output.
- Analog Audio: Output the analog audio routed to this unit.
- HDMI Audio (Stereo Downmix): Output the HDMI audio routed to this unit after
downmixing it to LPCM 2.0.
Note: This mode only supports HDMI sources with LPCM audio.
- HDMI Audio (All Channel): Output the HDMI audio routed to this unit.
Note: This mode only supports HDMI sources with LPCM audio.
• Analog Audio Source: Select the audio source type to output from the analog audio
output of this unit. Available options are:
- HDMI Audio (Stereo Downmix): Output the HDMI audio routed to this unit after
downmixing it to stereo.
Note: This mode only supports HDMI sources with LPCM audio.
- Analog Audio: Output the analog audio routed to this unit.
• HDMI Audio Follow Video: Enable or disable HDMI audio follow video rules for
this receiver. When enabled, any HDMI video source switched to this receiver will
automatically also route the that transmitter’s HDMI audio to this receiver.
Note: This setting overrides any manual routing selections made from the HDMI Audio routing tab.
• Analog Audio Follow Mode: Use the dropdown to select the automatic audio follow
behavior for this receiver’s analog audio output.
- Disable: Disables automatic following rules for analog audio on this receiver and
allows breakaway audio routing.
- Follow Rx HDMI Audio: Analog audio output routing will follow the HDMI audio
routing selections made on this receiver.
To Next Page
Loading...
