CAN RANGER OPERATION
25
goes high (active). The output
will ramp off to allow for a
smooth stop. If you do not
want either of these features,
just disable Input 1.
When you have made your
selection, press <SET>.
If you chose CW STOP, a CW
RAMP screen comes up. Use
the arrows to set the time for
the function to go from full
speed to stop. The maximum
number is 2000ms (2
second). The larger the
number, the longer it takes to
stop moving.
The next option is for Input 2.
The screen will appear:
INPUT2 DISABLE
THEN PUSH SET
Use ↑ or ↓ to switch between
DISABLE, OVL, and CCW
STOP modes for Input 2. OVL
Mode monitors Input 2, and
when it goes high (active),
the transmitter’s LEDs will
flash together when a joystick
is operated. In CCW STOP
mode, the Ranger Controller
will stop any swing CCW
motion by the transmitter
when this input goes high
(active). The output will ramp
off to allow for a smooth stop.
If you do not want either of
these features, just disable
Input 2.
When you have made your
selection, press <SET>.
If you chose CCW STOP, a
CCW RAMP screen comes up.
Use the arrows to set the time
for the function to go from full
speed to stop. The maximum
number is 2000ms. The larger
the number, the longer it
takes to stop moving.
To Next Page
Loading...
